![]() One of the trim patterns was selected for the upper brick trim. A brick pattern was chosen for the foundation. In the Service Station the building walls were chosen from one of the "Cement-Stucco" patterns. ![]() We have found that extra care is needed in this approach to locate windows and doors, and to bend the corners in exactly the right location. You can print a model with all of the sides printed on a single sheet of paper, as shown in the Service Station. In the Track Side Shed shown above each side of the model was printed on a single piece of paper. Spray a coat on your model when you are done building. We have found that KRYLON ® UV Resistant Clear Acrylic Coating- Matte, or "Preserve-It" work well. Over Spray Fixative Over spray protects the model from smudging and reduces UV light fading. Small Bar Clamps When you are gluing up the chipboard, adding the floor and gluing on the roof, these come in handy. For most models, a tan/brown pastel kit and a gray pastel kit will be adequate. Craft stores have a good selection of pastels. A good method of hiding the seam is to rub on a little pastel chalk that is close to the model's brick or siding color. The seam is typically white, and can be quite noticeable. Pastel Chalk You may have a seam where the paper ends at the corners of models.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |